Detailed Product Description
| High Light: |
swimming pool controller, swimming pool remote control systems |
Embedded Type Filtration System Swimming Pool Control System With Suction Unit
Description:
Box body is made of high quality acrylic material, beautiful appearance, exquisite design, strong and durable. Without machine room, save the money into building room, also need not in the building the other accessory structure and convenient operation, low management cost. Body, the filter can be installed in the swimming pool pool and pool forming an organic whole, will not affect the landscape surrounding the pool Settings. Change selection pool dedicated big flow pump equipment, is equipped with two stream nozzle, can play the function effect under training.
* Adopt advanced membrane filtration technology, high filtration precision, simple cleaning, also equipped with disinfection sterilization system, to the bottom of the pool sludge absorption function, reduce the consumption of the swimming pool chemicals, save water resources
* Overflow surface water design, effectively pool overflow surface skimming effect
* Detachable wide front end cover structure design, solve the problem of equipment and construction decoration, can be integrated with the swimming pool
Including: Before and after the box cover, box, junction box, pill machine, water pump, filter system, handle, water grate, stream nozzle, underwater light, suction device
INSTALLATION:
1. Clear away any debris from the installation area, and make a datum mark before installation.
2. Place the unit in a proper position according to the installation detail drawing. Adjust the unit with a level to make sure the tolerance is less than 2mm, use the filter pieces to pack the unit level, fix the packing pieces, then fill in th vacant area with grout.
3. Connect drainpipe and cable pipe as shown in the installation detail drawing. The control box must be damp proofed. Electrical installtion and testing must be done by a licensed or certified electrician.
4. Fill in the joint between the unit and pool wall with grout when installing, and seal with sealant.
5. After installation, fill with sand around the unit body. Spread stones on the side of pool to match the pool structure, record the installation notes.
| power |
voltage |
flow rate |
filtration fineness |
filtration area |
running noice |
size |
| 4.0HP |
220V |
45-50m3/h |
≤5μ |
3.15m 2 |
≤40dB |
1220x1245x1100mm |
